Intermec 2430 User Guide
Chapter 6—Configuration Command Reference
192
Trakker Antares 2400 Family System Manual
Host IP Address
Terminals: 2415, 2425, 2435, 2455, 2461, 2475, 2480/1 with the Ethernet option,
and 2485/6 using the TCP/IP network.
Description: Defines the IP address assigned to the host computer in your RF or
Ethernet network. An IP address is a unique network level address you
assign to each device in a TCP/IP direct connect network. The host IP
address you set on the terminal must match the address that is set on the
host.
assign to each device in a TCP/IP direct connect network. The host IP
address you set on the terminal must match the address that is set on the
host.
Syntax: NCn.n.n.n
where each n address segment is a number from 0 to 255. The host IP
address field consists of four separate numbers, each separated by a period.
address field consists of four separate numbers, each separated by a period.
Note: The RF or Ethernet network cannot be activated if the first address
segment in the IP address is set to 0, 127, or a number greater than 223.
segment in the IP address is set to 0, 127, or a number greater than 223.
Default: 0.0.0.0
Menu System: Main Menu > Configuration Menu > Communications Menu > Primary
Network
Bar Codes: To set the default host IP address, scan this bar code:
Default Host IP Address
*$+NC0.0.0.0*
*$+NC0.0.0.0*
Or: To set the host IP address:
1
Scan this bar code:
Enter Accumulate Mode / Set Host IP Address
*+/$+NC*
*+/$+NC*
2
Scan a numeric value from 0 to 255 to set an n field of the host IP
address from these bar codes.
address from these bar codes.
*0*
*1*
*0*
*1*
*2*
*3*
*2*
*3*
*4*
*5*
*4*
*5*
*6*
*7*
*6*
*7*