Intermec 2430 User Guide
Chapter 6—Configuration Command Reference
Trakker Antares 2400 Family System Manual
193
*8*
*9*
*8*
*9*
3
Scan this bar code:
. (Period)
*.*
*.*
4
Repeat Steps 2 and 3 to set the next three numbers in the host IP
address field. After you scan the last address segment, go to Step 5. Do
not scan the period after the last address segment.
address field. After you scan the last address segment, go to Step 5. Do
not scan the period after the last address segment.
5
Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
ICMP (Internet Control Message Protocol)
Terminals: 2415, 2425, 2435, 2455, 2475, and 2485/6.
Description: Enables or disables ICMP messages sent from the terminal.
Syntax: NZdata
Acceptable values for data are:
0
Disable ICMP messages
1
Enable ICMP messages
Default: Enabled
Menu System: Not
supported
Bar Codes: Scan one of these bar codes:
Disable ICMP Messages
Enable ICMP Messages
*$+NZ0*
*$+NZ1*
*$+NZ0* *$+NZ1*
Inactivity Timeout
Terminals: 2415, 2425, 2435, 2455, 2475, and 2485/6 with OpenAir radios.
Description: Defines the amount of time the radio on the terminal waits to go into a
low power state. If no data is sent or received within the inactivity timeout
period set, the radio goes into a low power state to conserve power. If you
set a high value, the radio stays on longer at a higher power rate and uses
power at a faster rate.
period set, the radio goes into a low power state to conserve power. If you
set a high value, the radio stays on longer at a higher power rate and uses
power at a faster rate.