Intermec 2430 User Guide
Chapter 6—Configuration Command Reference
Trakker Antares 2400 Family System Manual
211
Default: Disabled
Menu System: Main Menu > Configuration Menu > Communications Menu > Primary
Network
Bar Codes: Scan one of these bar codes:
Disable Network Activate
Enable RF or Ethernet Network
*$+NA0*
*$+NA1*
*$+NA0* *$+NA1*
Network Loopback
Terminals: 2415, 2425, 2435, 2455, 2475, and 2485/6.
Description: Transmits all messages received from the Intermec Gateway or DCS 30X
back to the Intermec Gateway or DCS 30X. Messages received by the
radio are not passed on to the terminal applications unless they are
configuration commands. Messages continue to be looped back to the
Intermec Gateway or DCS 30X as long as this feature is enabled. Messages
originating from the terminal are still transmitted to the Intermec Gateway
or DCS 30X.
radio are not passed on to the terminal applications unless they are
configuration commands. Messages continue to be looped back to the
Intermec Gateway or DCS 30X as long as this feature is enabled. Messages
originating from the terminal are still transmitted to the Intermec Gateway
or DCS 30X.
Use the Network Loopback parameter to troubleshoot RF or Ethernet
communications problems.
communications problems.
Syntax: NLdata
Acceptable values for data are:
0 Disabled
1 Enabled
1 Enabled
Default: Disabled
Menu System: Main Menu > Configuration Menu > Communications Menu > Advanced
Network
Bar Codes: Scan one of these bar codes:
Disable Network Loopback
Enable Network Loopback
*$+NL0*
*$+NL1*
*$+NL0* *$+NL1*
Network Name
Terminals: 2415, 2425, 2435, 2455, 2475, and 2485/6 with 802.11b radios.
Description: Defines an RF subnetwork. To communicate, all access points and RF
terminals in the subnetwork must have the same network name, which is
case-sensitive. If you set this parameter to “ANY,” the terminal can
case-sensitive. If you set this parameter to “ANY,” the terminal can