Intermec m90 Reference Guide
Operation Modes
—
Chapter 3
33
M90 Series Portable Data Entry Unit Reference Manual
MSI 2nd Check Digit
Press A or " to select one of five verification types: “OFF” (default),
“MOD 10/NO SEND,” “MOD 10/SEND,” “MOD 11/NO SEND,” or
“MOD 11/SEND,” then press [ENT SCAN].
“MOD 10/NO SEND,” “MOD 10/SEND,” “MOD 11/NO SEND,” or
“MOD 11/SEND,” then press [ENT SCAN].
<BARCODE SETUP>
2nd CHECK DIGIT
OFF
_
2. TERM (Terminal Configuration)
Select option 2.TERM from the Supervisor Mode menu for the Terminal
Setup menu. Parameters are set up in this menu like they are set up in the
Device Config menu. The M90 supports a terminal emulator that acts as a
dumb ASCII computer.
Setup menu. Parameters are set up in this menu like they are set up in the
Device Config menu. The M90 supports a terminal emulator that acts as a
dumb ASCII computer.
TERM I.D. (Terminal ID)
ASCII string IDs identify each M90 Computer. IDs take up to eight char-
acters. The initial ID is “M90.” Alphanumeric characters (“A”-“Z”,
“a”-“z”, “0”-“9”) are valid. Press [ENT SCAN] to continue.
acters. The initial ID is “M90.” Alphanumeric characters (“A”-“Z”,
“a”-“z”, “0”-“9”) are valid. Press [ENT SCAN] to continue.
<< TERM SETUP >>
TERM I.D.
M90
ONLINE
Press " to toggle between “REMOTE” (default) or “LOCAL,” then press
[ENT SCAN]. “REMOTE” immediately transmits scanned bar code data
or key data to the host or PC using the RS-232 port, “LOCAL” does not
transmit data.
[ENT SCAN]. “REMOTE” immediately transmits scanned bar code data
or key data to the host or PC using the RS-232 port, “LOCAL” does not
transmit data.
<< TERM SETUP >>
ONLINE
REMOTE
_