Intermec m90 Reference Guide
Operation Modes
Chapter
—
3
34
M90 Series Portable Data Entry Unit Reference Manual
ECHO
Press " to toggle between “ON” (default) or “OFF,” then press
[ENT SCAN]. Select “ON” to view any collected data.
[ENT SCAN]. Select “ON” to view any collected data.
<< TERM SETUP >>
ECHO
ON
_
AUTOLF
Press " to toggle between “ON” (default) or “OFF,” then press
[ENT SCAN]. Select “ON” to append a linefeed (10 hex) character to the
input data block.
[ENT SCAN]. Select “ON” to append a linefeed (10 hex) character to the
input data block.
<< TERM SETUP >>
AUTOLF
ON
_
MODE
Press " to toggle between “BLOCK” or “CHAR” (default), then press
[ENT SCAN].
[ENT SCAN].
<< TERM SETUP >>
MODE
CHAR
_
LINE/PAGE
If “BLOCK” is selected under Mode, then LINE/PAGE is enabled. The
LINE/PAGE entry designates the termination character set as “LINE” to
terminate the line: CR (0D hex), “PAGE” to terminate the page: CTRL-Z
(1A hex), or “BOTH” to terminates both the line and page. CR and
CTRL-Z (0D and 1A hex). Press " to toggle among “LINE” (default),
“PAGE,” or “BOTH,” then press [ENT SCAN].
LINE/PAGE entry designates the termination character set as “LINE” to
terminate the line: CR (0D hex), “PAGE” to terminate the page: CTRL-Z
(1A hex), or “BOTH” to terminates both the line and page. CR and
CTRL-Z (0D and 1A hex). Press " to toggle among “LINE” (default),
“PAGE,” or “BOTH,” then press [ENT SCAN].
<< TERM SETUP >>
LINE/PAGE
LINE
_