Intermec 2410 User Guide

maximum amount of time to charge a fully discharged battery. It 
may take less time depending on the state of the battery charge. 

1350 mAh single-cell (P/N 069428) 

1.25 hours 

2700 mAh dual-cell (P/N 069429) 

2.5 hours 

2400 mAh single-cell (P/N 073929) 

5 hours 

4800 mAh dual-cell (P/N 073930) 

9 hours 

 

 

Align the battery pack 
with a battery slot on 
the charger (as shown 
in the illustration) and 
slide the battery pack 
down until it fits 
firmly in the charger. 
To unload a battery 
pack from the charger, 
simply pull it out of 
the battery slot. You 
can unload and use a 
battery pack before it 
has been fully charged. 

241XI003.eps

Status  
LEDs

Power supply
jack

Battery
slot

 

Each battery slot has two status LEDs that indicate the status of the 
battery pack in the slot. 

Yellow 

The battery pack is charging or cold. 

Green 

The battery pack is fully charged or over heated. 

Off 

The battery slot is empty or the charger is not plugged in. 

Flashing Yellow 

There has been a charge interrupt or timeout. 

•  Use only Intermec-labeled lithium-ion battery packs (P/N 069428, 

P/N 069429, P/N 073929, or P/N 073930) in the battery charger. 

•  Charge the battery pack immediately before use or within a couple 

of days of use. 

•  For maximum battery efficiency, the recommended temperature 

range when charging is 25°C (77°F). 

•  While the charger is in use, it becomes warm. This is normal. 

•  Remove the battery pack from the charger within 24 hours after 

charging is completed. 

•  Keep the battery and charger contacts clean and free of dust and 

dirt. Remove any accumulated debris using a non-metallic pointed 
object. 

•  Do not let anything metallic come into contact with the battery 

charger contacts. 

•  Do not disassemble the charger. There are no user-serviceable parts 

in the charger. 

•  Do not place the charger in locations that are extremely hot or 

cold, dusty or dirty, very humid, or subject to vibration. 

•  If any part of the charger appears worn or damaged, or if any 

difficulty arises while using the battery charger, unplug the battery 
charger immediately and contact your Intermec service 
representative. 

If the charger does not charge the battery pack or if the LEDs do not 
light, try the following solutions: 
•  Make sure that the charger is plugged in to an electrical outlet and 

that the electrical outlet has power. 

•  Clean the contacts on the charger and battery pack with a cotton 

swab and isopropyl alcohol.