Intermec 2400 Quick Setup Guide
7
6
6. (2455, 2475) Install and connect the DC
power supply and charge the backup
battery.
battery.
7. (2455, 2475) Connect to input devices and
serial devices.
For help, see the getting started guide or quick
start guide that ships with the terminal.
start guide that ships with the terminal.
Installing and Connecting
Power and Battery Packs
Power and Battery Packs
The 2415, 2425, and 2435 use a lithium-ion
battery pack as the main power source. These
terminals also have a backup battery or power
source. You must charge and install the battery
packs before using the terminal.
battery pack as the main power source. These
terminals also have a backup battery or power
source. You must charge and install the battery
packs before using the terminal.
The 2455, 2475, and 2481/6 use an external
power supply and a backup battery. You need
to connect and install power and charge the
backup battery before using the terminal.
power supply and a backup battery. You need
to connect and install power and charge the
backup battery before using the terminal.
To charge and install the battery packs
for the 2415, 2425, and 2435
for the 2415, 2425, and 2435
Caution
The lithium-ion battery pack that is
used in this device may present a
fire or chemical burn hazard if it is
The lithium-ion battery pack that is
used in this device may present a
fire or chemical burn hazard if it is
mistreated. Do not disassemble it, heat it
above 100ºC (212ºF), or incinerate it.
above 100ºC (212ºF), or incinerate it.
Conseil
Le paquet de piles d’ions de lithium qui
est utilisé dans cet appareil peut presenter
un risque feu ou un risque chimique de
brûlure s’il est maltraité. Il ne faut pas le
désassembler, le réchauffer à une température
plus élevée que 100
Le paquet de piles d’ions de lithium qui
est utilisé dans cet appareil peut presenter
un risque feu ou un risque chimique de
brûlure s’il est maltraité. Il ne faut pas le
désassembler, le réchauffer à une température
plus élevée que 100
o
C (212
o
F), ou l’incinérer.
1. Charge the battery pack by placing it in an
empty slot in the battery charger.
2. (2425) Open the battery door and connect
the backup battery.
3. Install the battery pack.
To connect and install power for the 2455
and the 2475
and the 2475
•
Refer to the Trakker Antares 2455/2475
DC Power Supply Installation Instructions
(Part No. 067362).
DC Power Supply Installation Instructions
(Part No. 067362).
To connect and install power for the 2481/6
1. Remove the back panel.
2. Connect the power supply to the power
source and the terminal and charge the
backup battery.
backup battery.
Turning on the Terminal
1. Press the 1/0 key. The terminal runs POST
(power-on self test), and then the Boot
Menu appears.
Menu appears.
2. Press the appropriate key to boot the
terminal and initialize the firmware. The
Oracle-Ready screen appears.
Oracle-Ready screen appears.
Configuring the
Operations Parameters
Operations Parameters
Before you can start using the terminal, you
need to configure the Time and Date command
and the Preamble command.
need to configure the Time and Date command
and the Preamble command.
2
3
24XXOR001.eps
4