Intermec 2400 Quick Setup Guide
9
8
To set the time and date
1. Scan this bar code to access the TRAKKER
Antares 2400 Menu System:
TRAKKER Antares 2400 Menu System
*..-.*
*..-.*
2. Select the System Menu and press the
Enter key. Select the Set Time and Date
command and press the Enter key.
command and press the Enter key.
3. Enter the current time in the format
HH:MM:SS (hours, minutes, seconds),
and enter the current date in the format
YYYY:MM:DD (year, month, day). You
must enter the colon character (:).
and enter the current date in the format
YYYY:MM:DD (year, month, day). You
must enter the colon character (:).
4. Press the Enter key, and then press the
Esc key.
To configure the preamble
1. From the Main Menu, choose
Configuration Menu, Terminal Menu,
and then choose Preamble/Postamble.
and then choose Preamble/Postamble.
2. Enter \x1C in the Preamble field. Oracle
recognizes the data as bar code data based
on this preamble.
on this preamble.
3. Press the Enter key, and then press the
Esc key twice.
Configuring the
Network Parameters
Network Parameters
1. From the Main Menu in the TRAKKER
Antares 2400 Menu System, choose
Configuration Menu, Communication
Menu, and then choose Primary Network or
Advanced Network.
Configuration Menu, Communication
Menu, and then choose Primary Network or
Advanced Network.
5
2. Configure the Primary Network parameters:
•
Activate field set to 2.4 GHz RF or
802.11 DS. If you are using a WTP
network, this is the only Primary
Network parameter you need to set.
802.11 DS. If you are using a WTP
network, this is the only Primary
Network parameter you need to set.
•
(TCP/IP) Host IP Address field set to
the IP address of the host that you
want the terminal to communicate with.
the IP address of the host that you
want the terminal to communicate with.
(UDP Plus) Controller IP Address field
set to the IP address of the DCS 30X.
set to the IP address of the DCS 30X.
•
Terminal IP Address field set to the IP
address of the terminal. If the terminal is
a DHCP client, use the default value of
0.0.0.0.
address of the terminal. If the terminal is
a DHCP client, use the default value of
0.0.0.0.
3. Configure the Advanced Network
parameters:
Note: You do not need to configure the
Advanced Network parameters for WTP.
Advanced Network parameters for WTP.
•
(TCP/IP) Network Port set to the
appropriate port for the application
on the terminal. The default value 23
enables VT/ANSI Telnet
communications.
appropriate port for the application
on the terminal. The default value 23
enables VT/ANSI Telnet
communications.
•
(UDP Plus) Network Port set to the
network port on the DCS 30X. The
default value 5555 matches the default
value set on the DCS 30X.
network port on the DCS 30X. The
default value 5555 matches the default
value set on the DCS 30X.
Note: If you are using the terminal as a
DHCP client, you do not need to set the
subnet mask and default router.
DHCP client, you do not need to set the
subnet mask and default router.
•
Subnet Mask field set to the mask that
separates the subnetwork address from
the terminal IP address.
separates the subnetwork address from
the terminal IP address.
•
Default Router field set to the IP
address of the default router.
address of the default router.
4. Press the Esc key twice to return to the
Main Menu.