Intermec 2480 Installation Instruction

You can attach the COM4 adapter cable (Part No. 067185) to a TRAKKER



 Antares



 2480,

2481, 2485, or 2486 (T248X) terminal to use an additional serial port for RS-232 serial
communications. COM4 is only available on a T248X with the option for the enhanced
input/output board.

1. Use a Phillips screwdriver to remove the six screws on the back panel.

2. Remove the back panel and place it on a clean surface.

3. Connect the COM4 adapter cable to the COM4 connector.

248XIC4C.001

Back panel

Screw
(6 places)

Cable
restraint
bar

Scissors
seal

COM4
connector

COM4
adapter
cable

9-pin
RS-232
connector

Cable
restraint

4. Use a Phillips screwdriver to loosen one of the screws on the cable restraint. Route the

COM4 adapter cable under the cable restraint. Tighten the screw to secure the cable.

5. Route the COM4 adapter cable under the cable restraint bar and through the scissors seal.

6. With the seal facing toward the terminal, place the back panel on the back of the terminal.

7. Use a Phillips screwdriver to tighten the six screws to 19 in-lb torque.