Intermec 2480 Quick Setup Guide

nugget  

d 39

 

The steps to install your 248X depend on the options you purchased and 
the type of network or devices to which you want to connect the terminal. 
Use these next steps to install and configure your terminal. 

Attach the antenna on a 2485 or 2486. See page 11. 

If you have a wall-mount bracket, install it and install the terminal in 
the wall-mount bracket. See page 12. 

Connect the power supply and input devices to the 248X. See page 13. 

Charge the backup battery. See page 14. 

Connect the 248X to serial devices or networks. See page 15. 

Connect the 2480 or 2481 directly to an Ethernet network. See page 
17. 

Connect the 2485 or 2486 to an RF network. See page 18. 

If you have a desk-mount bracket, install it and install the terminal in 
the desk-mount bracket. See page 11. 

Before you get started, use the next section to learn about the connectors 
and components inside the rear enclosure of the terminal. 

To install the 248X, you must remove the back panel to connect power, 
input devices, and communications ports. The next illustration shows all 
the connectors on a 2480 or 2481 that has an enhanced input/output 
board and the Ethernet option. 

248XG.025

5

1

6

2

3

4

7

9 

8