Intermec 2480 Supplementary Manual

The desk-mount bracket easily attaches to your TRAKKER



 Antares



 2480,

2481, 2485, or 2486 terminal. The bracket can be either seated on or mounted to
your desk.

The desk-mount bracket kit (Part No. 066709) contains these parts:

•

Desk-mount bracket base

•

Two arms

•

Four nuts

•

Cable organizer

•

Power supply holder

•

Five mounting screws

•

Four adhesive feet

•

Cable tie wraps

To mount the bracket, you need to provide four 5/16-inch (8mm) diameter
bolts with flat washers, lock washers, and nuts. The length of the bolts depends
on the thickness of the mounting surface.

1. Using the base as a template, mark and drill four holes in the desk top.

2. Attach the base using four bolts.

1. Unfasten the knob keeping the washers and arm brake on the knob.

2. Remove the first rubber washer.

3. Orient the right arm as shown in the illustration on the next page and place

it on the knob.

4. Replace the rubber washer.

5. Make sure that the arm brake is hooked onto the base of the bracket and

fasten the knob back onto the base.

6. Repeat Steps 1 through 5 with the bolt and left arm. Tighten the bolt finger

tight plus one quarter turn. The left arm should swing up and down with
the bolt fastened.

The right arm controls the angle of the terminal. To set the angle, loosen the
knob, adjust the terminal to the position you choose, and tighten the knob.