Intermec 2480 Quick Setup Guide
nugget
d 39
Trakker Antares 248X Stationary Terminal Quick Start Guide
17
• Multi-Drop address
For help, see “Using the Menu System to Configure the Terminal” on
page 20.
page 20.
2
Configure your 9154 or 9161 controller to add the new multi-drop
248X device. For help, see your controller user’s manual.
248X device. For help, see your controller user’s manual.
Connecting Directly to an Ethernet Network
The Trakker Antares 2480 and 2481 terminals have an option for an
Ethernet (10BaseT) card. With this option, your terminal can
communicate to a host or any device on an Ethernet network.
Ethernet (10BaseT) card. With this option, your terminal can
communicate to a host or any device on an Ethernet network.
To connect to an Ethernet network
1
Configure your host computer and network. Assign an IP address for
the 2480 or 2481.
the 2480 or 2481.
2
Connect the Ethernet jack to the Ethernet connector on the back of the
terminal.
terminal.
248XG.038
To Ethernet
network
network
Ethernet
connector
connector
Cable
restraint bar
restraint bar
Scissors seal
3
Use a Phillips screwdriver to loosen one of the screws on the cable
restraint. Route the Ethernet cable under the cable restraint. Tighten
the screw to secure the cable.
restraint. Route the Ethernet cable under the cable restraint. Tighten
the screw to secure the cable.
4
Route the cable under the cable restraint bar and through the scissors
seal.
seal.
5
With the seal facing toward the terminal, place the back panel on the
back of the terminal.
back of the terminal.
6
Use a Phillips screwdriver to tighten the six screws to 2.15 Nm
(19 in-lb) torque.
(19 in-lb) torque.