Intermec 2480 Quick Setup Guide

nugget

d 39

Trakker Antares 248X Stationary Terminal Quick Start Guide

Press • to exit the System Menu. The Main Menu appears.

Choose Configuration Menu,
and then press ;. The
Configuration Menu appears.
Use the Communications Menu to
configure the network parameters
and the serial port parameters.

Press • to exit the Configuration
Menu. When prompted, save your
changes to RAM.

Press • to exit the Main Menu

CONFIGURATION

Symbologies

Symbology

IDs

Communications

Terminal

Select

item

[Enter]

screen

[F1]

Help

[Esc]

Exit

248XG.015

and save your changes in flash memory.

If you are using the Wavelink Avalanche client management system, you
can quickly configure the parameters for your terminal. For help, see
Chapter 2, “Configuring and Managing the Terminals,” in the 2400
Family system manual.

Choosing Your TE 2000 Application

If you ordered a TE 2000 application, your terminal is configured for
TE 2000 VT/ANSI by default. You may need to change the configuration
to TE 2000 5250 or TE 2000 3270.

To choose your TE 2000 configuration

On your terminal, press ( ¡.
The TE 2000 main menu appears.

Select Set-up Parms and press
;. A password prompt appears.

Type C R 5 2 4 0 1
and press ;.

Select Protocol Opts, Data
Stream, and then select the
appropriate TE 2000
configuration.

Main Menu

1) Set-up Parms
2) LCD Parms
3)
4) Tests
5) Version Info
6) Exit Menus
7) More

24XXS080.eps

Save your changes by selecting Exit Menus from the TE 2000 main
menu. Press Y, and type C R 5 2 4 0 1 at the Enter
Password prompt.

Your TE 2000 application also comes with the appropriate TE 2000
keypad overlay. For more information, see the next section, “Using the
Keypad.” For information about using TE 2000 terminal emulation, see
the appropriate TE 2000 guide listed in “Where to Go From Here” on the
last page of this guide.