Intermec 2480 User Guide

5. Insert and tighten the two mounting screws to secure the badge scanner to the

terminal.

6. Take out the six screws and remove the terminal’s back panel. Save and reuse the

screws to replace the back panel.

Badge
scanner

Badge
scanner
cable

Badge 
scanner
connector

Scissors
seal

Cable
restraint

248XBRI.006

7. Keeping the scanner cable snug against the bottom edge of the rear enclosure, gently

pull up on the scissors seal, pass the cable through the seal and under the cable
restraint bar, and close the seal.

8. Loosen the screw on the cable restraint and pass the scanner cable under the cable

restraint. Tighten the screw to secure the cable.

9. Plug the badge scanner cable into the badge scanner connector.

10. Replace the terminal’s back panel and remount the terminal on the desk or wall.

11. Plug in the power supply and turn on the terminal.

6001 36th Avenue West
P.O. Box 4280
Everett, WA 98203-9280

© 1998  Intermec Corporation
All Rights Reserved