Intermec 1470 User Guide
1470/1471 Imager User’s Manual
4-24
Or scan one of the following bar codes.
Minimum Message Length
Maximum Message Length
After reading this programming bar code, you must input the desired message length
and Save. Refer to the “General Programming Chart” in Appendix B.
and Save. Refer to the “General Programming Chart” in Appendix B.
MSI
For the default settings, see Chapter 7, “Default Charts.”
Default All MSI Settings
MSI On/Off
The default setting is marked with an asterisk (*).
On
Off
*
Message Length
The message length selection is used to set the valid reading length of the bar code. If
the data length of the scanned bar code doesn’t match the valid reading length, the
imager will issue an error beep. You may wish to set the same value for minimum and
maximum length to force the imager to read fixed length bar code data. This
configuration helps reduce the chances of a misread.
the data length of the scanned bar code doesn’t match the valid reading length, the
imager will issue an error beep. You may wish to set the same value for minimum and
maximum length to force the imager to read fixed length bar code data. This
configuration helps reduce the chances of a misread.
Example
Decode only those bar codes with a count of 9-20 characters.
Minimum length = 09
Maximum length = 20