Intermec 1470 User Guide

Or scan the Interfunction Delay bar code below, then scan the number of steps and the
Save bar code from the “General Programming Chart” in Appendix B.

If you make an error while scanning the digits (before scanning Save), scan

Discard in the “General Programming Chart” in Appendix B, and then scan the correct
digits and Save again.

Interfunction Delay

To remove this delay, scan the Interfunction Delay bar code, then set the number of
steps to 00. Scan the Save bar code from the “General Programming Chart” in
Appendix B.

This is a delay of up to 495 milliseconds (in multiples of 5) placed between each scan
transmission. You can program up to 99 steps (of 5 ms each).

In the Output tab of Visual Menu, enter a value from 0 to 99 in the Intermessage (x

5ms) field. Click the Write Settings to Device button (

) to send the new setting to

the imager.

2nd Scan Transmission

1st Scan Transmission

Intermessage Delay