Intermec 1470 User Guide

Or scan the Intercharacter Delay bar code below, then scan the number of steps and the
Save bar code from the “General Programming Chart” in Appendix B.

If you make an error while scanning the digits (before scanning Save), scan

Discard in the “General Programming Chart” in Appendix B, and then scan the correct
digits and Save again.

Intercharacter Delay

To remove this delay, scan the Intercharacter Delay bar code, then set the number of
steps to 00. Scan the Save bar code from the “General Programming Chart” in
Appendix B.

This is a delay of up to 495 milliseconds (in multiples of 5) placed between the
transmission of each segment of the message string. You can program up to 99 steps (of
5 ms each).

In the Output tab of Visual Menu, enter a value from 0 to 99 in the Interfunction (x

5ms) field. Click the Write Settings to Device button (

) to send the new setting to

the imager.

Interfunction Delays

Prefix

Scanned Data

Suffix

1

2

3 4

5

STX

HT

CR

LF