Intermec SR60 Reference Guide

If you need to move the scanner to a host terminal of a different 
interface type, you simply connect the scanner to the new host 
using the appropriate interface cable. The scanner automatically 
changes to the interface functions specific to that cable.

You must make sure that your SR60 scanner supports the 
interface you want to change to. The following list indicates the 
interfaces each SR60 scanner supports: 

• SR60 scanner with C/N SR60BX01 (XLR) or 

 

C/N SR60BL01 (SR) supports the Wand Emulation, 

 

RS-232, and Keyboard Wedge interfaces.

• SR60 scanner with C/N SR60BX02 (XLR) or 

 

C/N SR60BL02 (SR) supports the USB interface.

• SR60 scanner with C/N SR60BX03 (XLR) supports the

 

Laser Emulation interface.

You can find the scanner C/N on the label above the trigger.

You can change your scanner interface cable by following these 
instructions.

Loosen the screw at the bottom of the handle. This screw is 
captive and does not come all the way out. 

Swing the forked cable retainer clear of the square hole in the 
end cap and rotate away from the cable.

Note: The part numbers for the keyboard wedge cables available 
from Intermec are listed in the “PC Keyboard Interfaces and 
Cables Supported ” table on page 20.