Intermec SR60 Reference Guide
Chapter 1 — Learning About Programming the SR60 Scanner
10
SR60 Scanner Programmer’s Reference Manual
3
Holding the scanner handle and end cap together in one
hand, pull the connector out of the handle end cap to free the
interface cable.
hand, pull the connector out of the handle end cap to free the
interface cable.
4
Connect the new interface cable at the scanner and rotate the
forked cable retainer to secure it. Tighten the screw to 0.67 to
1.13 Nm (6 to 10 in-lb).
forked cable retainer to secure it. Tighten the screw to 0.67 to
1.13 Nm (6 to 10 in-lb).
Removing and Replacing an Interface Cable
Reconfiguring the Interface Settings
If you change the interface cable, you may need to reconfigure
the interface settings. For help, see Chapter 2, “Configuring
Interface Settings.”
the interface settings. For help, see Chapter 2, “Configuring
Interface Settings.”
After you reconfigure the interface settings, you should scan a bar
code to verify that the scanner communicates correctly with the
new host system. For sample bar codes, see “Sample Bar Codes”
on page 158.
code to verify that the scanner communicates correctly with the
new host system. For sample bar codes, see “Sample Bar Codes”
on page 158.
3
1
2