Revel embrace User Guide
Figure 10. Installing closed-end
outer brackets on a wall.
outer brackets on a wall.
MOUNTING
EMBRACE surrounds are available in two versions. The wall-mount
version includes a pair of wall brackets and hardware. The ceiling-
mount version includes additional hardware for ceiling installations.
version includes a pair of wall brackets and hardware. The ceiling-
mount version includes additional hardware for ceiling installations.
MOUNTING AN EMBRACE ON A WALL
1. Determine wall locations for each pair of left and right
EMBRACE surrounds (see Placement starting on page 6).
2. At each proposed site, use a stud finder to locate the nearest
studs, which should be on 16-inch centers.
NOTE: The EMBRACE wall-mount hardware must be securely
attached to studs at their centers. Do not attach the hardware to
drywall or plaster!
attached to studs at their centers. Do not attach the hardware to
drywall or plaster!
3. Use tape to attach the enclosed wall-mount templates to the
walls, leaving a minimum clearance of 3
1
⁄
2
" (89 mm) from the
cabinet top to the ceiling. Use a level to verify tilt is zero.
NOTE: Be sure to account for any mouldings when determining a
minimum clearance distance. Refer to Figure 10 below.
minimum clearance distance. Refer to Figure 10 below.
4. At each site, drill six (6)
3
⁄
32
" (2.5 mm) holes at the designated
locations on the wall-mount template. Also create a cutout for
speaker wire within the noted boundary.
speaker wire within the noted boundary.
NOTE: The cutout should be wide enough to provide adequate
clearance to connect large spade lugs on terminal sides. Bi-wired or
Dual Drive™ connections will require even larger openings.
clearance to connect large spade lugs on terminal sides. Bi-wired or
Dual Drive™ connections will require even larger openings.
5. Install a pair of closed-end brackets, as shown in Figure 10.
EMBRACE
Owner’s Manual
12
OUTER
BRACKET
closed
end
end
wallboard
(top)
(top)
stud
stud
(6) #1
0 x 1
3
⁄
4
" L. Screws
OUTER
BRACKET
closed
end
end
16" centers
5
1
⁄
4
"
(134 mm)
minimum