Revel embrace Guia Do Utilizador

Figure 10. Installing closed-end
outer brackets on a wall.

MOUNTING

EMBRACE surrounds are available in two versions. The wall-mount
version includes a pair of wall brackets and hardware. The ceiling-
mount version includes additional hardware for ceiling installations.

MOUNTING AN EMBRACE ON A WALL

1. Determine wall locations for each pair of left and right

EMBRACE surrounds (see Placement starting on page 6).

2. At each proposed site, use a stud finder to locate the nearest

studs, which should be on 16-inch centers.

NOTE: The EMBRACE wall-mount hardware must be securely
attached to studs at their centers. Do not attach the hardware to
drywall or plaster!

3. Use tape to attach the enclosed wall-mount templates to the

walls, leaving a minimum clearance of 3

⁄

" (89 mm) from the

cabinet top to the ceiling. Use a level to verify tilt is zero.

NOTE: Be sure to account for any mouldings when determining a
minimum clearance distance. Refer to Figure 10 below.

4. At each site, drill six (6)

⁄

" (2.5 mm) holes at the designated

locations on the wall-mount template. Also create a cutout for
speaker wire within the noted boundary.

NOTE: The cutout should be wide enough to provide adequate
clearance to connect large spade lugs on terminal sides. Bi-wired or
Dual Drive™ connections will require even larger openings.

5. Install a pair of closed-end brackets, as shown in Figure 10.

EMBRACE

Owner’s Manual

OUTER

BRACKET

closed
end

wallboard
(top)

stud

(6) #1

0 x 1

⁄

" L. Screws

OUTER

BRACKET

closed
end

16" centers

⁄

(134 mm)

minimum