Leviton 47611-gt4 Quick Setup Guide
Installation:
Align the mounting pins with the grid holes on the back of the enclosure. With the mounting
pin plungers in the "out" position, press the unit into the grid in the desired location, secure
by pushing the plungers in. (Figure 1)
pin plungers in the "out" position, press the unit into the grid in the desired location, secure
by pushing the plungers in. (Figure 1)
NOTE: To remove the bracket from the Gateway, loosen the nuts underneath the Gateway and
bracket combination, then slide the units apart.
NOTE: For information on installing the SMC or the Leviton Category 5e Voice and Data
Module, please see the instructions for those devices.
Cabling the Internet Gateway:
The Gateway has four network ports. The ports numbered 1-4 can be used to connect a
variety of equipment including: computers, printers, scanners or other network peripherals.
Additionally, the Gateway features a WAN port. The Gateway can replace an existing hub or
switch that has no more than four devices connected, or that hub/switch can be cascaded
with the Gateway (see the instruction sheet for your hub or switch). Any of the ports
numbered 1-4 can be used as an Uplink port.
variety of equipment including: computers, printers, scanners or other network peripherals.
Additionally, the Gateway features a WAN port. The Gateway can replace an existing hub or
switch that has no more than four devices connected, or that hub/switch can be cascaded
with the Gateway (see the instruction sheet for your hub or switch). Any of the ports
numbered 1-4 can be used as an Uplink port.
1. Complete the Pre-Installation Checklist on page 1. Ensure you have wired at least two
connectors back to the Category 5e Voice and Data Module in the SMC with Category 5e
cable, and you have marked these two connectors and their corresponding Voice & Data
Module ports "A" and "B". (Figure 2, page 5)
cable, and you have marked these two connectors and their corresponding Voice & Data
Module ports "A" and "B". (Figure 2, page 5)
2. Shutdown and power off your computer and modem.
3. Unplug the Cable/DSL modem’s patch cord from the Ethernet port in your computer. Use
it to connect the modem to the data connector marked "A".
Figure 1
2
Client Notes
7
DI-008-47611-00A
DI-008-47611-00A