Panasonic dmc-lc40 User Guide

Page of 106
15
ª Charging time and available recording time 
(LCD on, shooting once every 30 seconds, flash every other shot. Measured using 
supplied 16 MB SD Memory Card)
A Charging time
B Continuous recording time (recordable number)
ª Charging environment and charging error
• Charge the battery in a place with a temperature of 50 - 95 F (10 - 35 °C). (The battery 
should also be the same temperature)
• When charging starts, the status indicator blinks at about 2 second cycles. If, after charging 
starts, the status indicator blinks quicker, this indicates a charging error.
In this case, remove the AC adaptor from the electrical outlet, remove the battery and check 
if both room and battery temperature is too low or high and then charge it again. (It is not 
possible to cancel the error by only turning the power off/on.) If the problem persists, 
consult the dealer or your nearest servicentre.
Connecting to an Electrical Outlet
If you use an AC adaptor and connect it to an electrical outlet, you can use the camera 
without worrying about battery discharge. The connection method is the same as 
explained in “Charging the Battery”. (P14)
• During use, the camera becomes warm; this is not a malfunction.
In setting LCD monitor to ON
Approx. 150 min.
(equal to 300 still pictures)
In setting LCD monitor to OFF
Approx. 180 min.
(equal to 360 still pictures)
Supplied 
battery pack
Approx. 
120 min.
KC3-PP.book  15 ページ  2002年4月5日 金曜日 午前11時55分