Panasonic aj-spc700 User Manual

37

The user bits allow information, including memos that use up
to eight-digit base 16 numbers (date and time), to be
recorded in the Subcode area.   

Position the DISPLAY switch at [UB].

Position the TCG switch at [SET].
When the left digit starts blinking you can change the
value. 

Use CURSOR buttons to set the user bits.

 Shifts the target (blinking) digit to the right.

 Shifts the target (blinking) digit to the left.

 Advances the blinking number by one digit. 

 Winds back the blinking number by one digit.

Position the TCG at [F-RUN] or [R-RUN].

Go to the <TC/UB> screen from the MAIN OPERATION
page, and set the menu option UB MODE to “USER”.

When the TCG switch is positioned at [SET],
thumbnails cannot be manipulated.

The data set for the user bits are automatically saved and
retained even if the video camera-recorder is turned off.

If the menu option UB MODE is set to “REGEN”, the AJ-
SPC700P reads the user bits in the last frame of the last clip
recorded on a P2 card (clip with the most recent recording
date and time), and records that bit onto the next card. Note
that settings for the user bits are not recorded.
The menu option UB MODE can be found in the <TC/UB>
screen, which is accessible from the MAIN OPERATION
page. 

The AJ-SPC700P also records the time code and user bits
in the VIDEO AUX area. The value for the time code (VITC)
is the same as that of the time code (LTC) in the sub-code
area. The user bits (of VITC) also records special
information, including the shoting frame rate.

__)_

Card management data
z Frame update flag
z Recording start/stop 

#,52%2 'PINKUJDQQMࡍ࡯ࠫ㧞㧜㧜㧢ᐕ㧡᦬㧝㧝ᣣޓᧁᦐᣣޓඦ೨㧥ᤨ㧠㧡ಽ