Hisense kf-2302gwe User Guide
5
Fig .9
·In case of Use of Tapping Screws (for Installing
Remote Control Unit)
Make 4.8mm dia. holes in the wall. Insert rawl
plugs for appropriate mounting screws. (Fig.11)
plugs for appropriate mounting screws. (Fig.11)
3-4.Remove the Grille to Install the Indoor Unit
Basically, these models can be installed and wired
w
w
i
t
h
o
u
t
removing the grille. If access to any internal part
is needed, follow the steps as given below:
is needed, follow the steps as given below:
How to remove the grille
(1)Set the flap in the horizontal position.
(2)Unscrew the 2 screws.(Fig.12a)
(3)Remove the grille.(Fig.12b)
(a)Hold both corners of the air intake grille,
(2)Unscrew the 2 screws.(Fig.12a)
(3)Remove the grille.(Fig.12b)
(a)Hold both corners of the air intake grille,
t h e n
p u l l
out and up to open.
(b)Pull the lower part of the grille toward
you to remove.
(c)Use a standard screwdriver to push up the 3
t a b s
t o
remove the grille
.
How to replace the grille.
(1)Close the flaps.
(2)Reinstall the grille into the lower part while
How to replace the grille.
(1)Close the flaps.
(2)Reinstall the grille into the lower part while
a l i g
n
i
n
g
i t s
tabs on the upper part. (Fig.13a) Insert the tabs
in the slots and push the lower part of the
grille back into position.
in the slots and push the lower part of the
grille back into position.
(3)Press at each of the 4 tabs to completely close
the grille. Make sure that the grille and frame
are firmly fitted together.(Fig.13b)
are firmly fitted together.(Fig.13b)
3-5.Shape the Indoor side Tubing
1) Arrangement of tubing by directions
a)Right or left tubing
Cut out the corner of the right/left frame with
a)Right or left tubing
Cut out the corner of the right/left frame with
a hacksaw or the like.(Figs14 and 15)
b)Right-rear or left-rear tubing
In this case, the corner of the frame need not
In this case, the corner of the frame need not
be cut.
2)To mount the indoor unit on the rear panel:
Hang the 2 mounting slots of the unit on the
Hang the 2 mounting slots of the unit on the
u
p
p
e
r
tabs of the rear panel.(Fig.16)
F ig.1 0
Fig. 11
4 . 8 m m
dia.hole
dia.hole
Rawl plug
Screw cover
Flap
(Up and down air direction louvre)
Fig.12a
Air intake grille
Fig.12b
Fi g.13 a
Fig. 13b