3com 5500-ei pwr Installation Instruction

 

1-24 

        5            3         1           0    2000-04-02 20:55:12.2 

For detailed output description, see the corresponding command manual.  

Both the remote-ping client and the DHCP server are switches. Perform a remote-ping DHCP test 

between the two switches to test the time required for the remote-ping client to obtain an IP address 

from the DHCP server.  

Figure 1-3 Network diagram for the DHCP test 

 

 

 

z 

Configure DHCP Server(Switch B): 

Configure DHCP server on Switch B. For specific configuration of DHCP server, refer to the DHCP part 

of the manual.  

z 

Configure remote-ping Client (Switch A): 

# Enable the remote-ping client. 

<Sysname> system-view 

[Sysname] remote-ping-agent enable 

# Create a remote-ping test group, setting the administrator name to administrator and test tag to 

DHCP. 

[Sysname] remote-ping administrator dhcp 

# Configure the test type as dhcp.  

[Sysname-remote-ping-administrator-dhcp] test-type dhcp 

# Configure the source interface, which must be a VLAN interface. Make sure the DHCP server resides 

on the network connected to this interface.  

[Sysname-remote-ping-administrator-dhcp] source-interface Vlan-interface 1 

# Configure to make 10 probes per test.  

[Sysname-remote-ping-administrator-dhcp] count 10 

# Set the probe timeout time to 5 seconds. 

[Sysname-remote-ping-administrator-dhcp] timeout 5 

# Start the test.  

[Sysname-remote-ping-administrator-dhcp] test-enable 

# Display test results 

[Sysname-remote-ping-administrator-dhcp] display remote-ping results administrator dhcp