3com 5500-ei pwr Installation Instruction
2-7
[SwitchA-GigabitEthernet1/0/2] port trunk permit vlan 100
[SwitchA-GigabitEthernet1/0/2] port trunk permit vlan 200
# Configure GigabitEthernet 1/0/10 of Switch B.
[SwitchB] interface GigabitEthernet 1/0/10
[SwitchB-GigabitEthernet1/0/10] port link-type trunk
[SwitchB-GigabitEthernet1/0/10] port trunk permit vlan 100
[SwitchB-GigabitEthernet1/0/10] port trunk permit vlan 200
Configuring a Protocol-Based VLAN
Protocol-Based VLAN Configuration Task List
Complete these tasks to configure protocol-based VLAN:
Task
Remarks
Required
Required
Optional
Configuring a Protocol Template for a Protocol-Based VLAN
Configuration prerequisites
Create a VLAN before configuring the VLAN as a protocol-based VLAN.
Configuration procedure
Follow these steps to configure the protocol template for a VLAN:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enter VLAN view
vlan vlan-id
—
Configure the protocol template
for the VLAN
for the VLAN
protocol-vlan [ protocol-index ]
{ at | ip | ipx { ethernetii | llc |
raw | snap } | mode
{ ethernetii etype etype-id | llc
dsap dsap-id ssap ssap-id |
snap etype etype-id } }
{ at | ip | ipx { ethernetii | llc |
raw | snap } | mode
{ ethernetii etype etype-id | llc
dsap dsap-id ssap ssap-id |
snap etype etype-id } }
Required
By default, no protocol template
is configured for the VLAN.
is configured for the VLAN.
When configuring a protocol template for a protocol-based VLAN, use the at, ip or ipx keyword to
configure a standard template to match AppleTalk, IP, and IPX packets respectively, and use the mode
keyword to configure a user-defined template.