3com 8807 Reference Guide
306
C
HAPTER
20: 802.1
X
C
ONFIGURATION
C
OMMANDS
■
When the number of users is 2048, the handshake period value should be no
smaller than 2 minutes, and the handshake timeout times should be no less
than 3 times;
smaller than 2 minutes, and the handshake timeout times should be no less
than 3 times;
■
When the number of users is 1024, the handshake period value should be no
smaller than 1 minutes, and the handshake timeout times should be no less
than 3 times
smaller than 1 minutes, and the handshake timeout times should be no less
than 3 times
■
When the number of users is 512, the handshake period value should be no
smaller than 30 seconds, and the handshake timeout times should be no less
than 2 times.
smaller than 30 seconds, and the handshake timeout times should be no less
than 2 times.
Description
Use the dot1x timer command to configure the 802.1x timers.
Use the undo dot1x timer command to restore the default values.
When it is run, 802.1x enables many timers to control the rational and orderly
interacting of the Supplicant, the Authenticator and the Authenticator Server. This
command can set some of the timers (while other timers cannot be set) to adapt
the interaction process. It could be necessary for some special and hard network
environment. Generally, the user should keep the default values of the timers.
interacting of the Supplicant, the Authenticator and the Authenticator Server. This
command can set some of the timers (while other timers cannot be set) to adapt
the interaction process. It could be necessary for some special and hard network
environment. Generally, the user should keep the default values of the timers.
Related command: display dot1x.
Example
# Set the Authentication Server timeout timer is 150s.
[SW8800] dot1x timer server-timeout 150
reset dot1x statistics
Syntax
reset dot1x statistics [ interface interface-list ]
View
User view
Parameter
interface interface-list: Ethernet interface list expressed in the format interface-list
=interface-type interface-number [ to interface-type interface-number ] &<1-10>.
interface-type means the interface type; interface-number is the interface number.
Refer to command parameters in the "Port" section in the manual for the
respective meanings and value ranges of them. The interface number after the key
word to should be no smaller than the interface number before to. &<1-10> in
the command means that the preceding parameter can be entered up to 10 times.
=interface-type interface-number [ to interface-type interface-number ] &<1-10>.
interface-type means the interface type; interface-number is the interface number.
Refer to command parameters in the "Port" section in the manual for the
respective meanings and value ranges of them. The interface number after the key
word to should be no smaller than the interface number before to. &<1-10> in
the command means that the preceding parameter can be entered up to 10 times.
Description
Use the reset dot1x statistics command to reset the statistics of 802.1x.
This command can be used to re-perform information statistics if the user wants
to delete the former statistics of 802.1x.
to delete the former statistics of 802.1x.
When the original statistics is cleared, if no port type or port number is specified,
the global 802.1x statistics of the switch and 802.1x statistics on all the ports will
the global 802.1x statistics of the switch and 802.1x statistics on all the ports will