3com 2948-SFP Plus User Guide
C
HAPTER 13:
C
ONFIGURING
Q
UALITY
O
F
S
ERVICE
159
Egress Shaping Rates
Status — Defines the shaping status. The possible field values are:
Enable — Egress rate limiting is enabled on the interface.
No Limit — Egress rate limiting is disabled on the interface.
CIR — Indicates CIR as the interface shaping type.
CbS— Indicates CbS as the interface shaping type.
Defining
Bandwidth Settings
Bandwidth Settings
The Bandwidth Setup Page allows network managers to define the
bandwidth settings for a specified interface. Interface shaping can be
based on an interface and is determined by the lower specified value.
The interface shaping type is selected in the Bandwidth Setup Page.
bandwidth settings for a specified interface. Interface shaping can be
based on an interface and is determined by the lower specified value.
The interface shaping type is selected in the Bandwidth Setup Page.
The monitor user has no access to this page.
To configure Bandwidth Settings:
1 Click Device > QoS > Bandwidth > Setup. The Bandwidth Setup
Page opens.
Figure 87 Bandwidth Setup Page