3com S7906E Installation Instruction

 

1-16 

Enter system view 

— 

Enter RRPP domain view 

rrpp domain domain-id 

— 

Specify the current device as a 
transit node of the primary ring, 
and specify the primary port 
and the secondary port 

ring ring-id node-mode transit 
[ primary-port interface-type 
interface-number ] [ secondary-port 
interface-type interface-number ] level 
level-value 

Required 

Specify the current device as 
the assistant-edge node of the 
subring, and specify an edge 
port 

ring ring-id node-mode assistant-edge 
[ edge-port interface-type 
interface-number ] 

Required 

 

To activate an RRPP domain on the current device, enable the RRPP protocol and RRPP rings for the 

RRPP domain on the current device.  

Perform this operation on all nodes in the RRPP domain.  

Follow these steps to activate an RRPP domain: 

Enter system view 

— 

Enable RRPP 

Required 

Disabled by default 

Enter RRPP domain view 

rrpp domain domain-id 

— 

Enable the specified RRPP ring  ring ring-id enable 

Required 

Disabled by default 

 

On an edge node or assistant-edge node, enable/disable the primary ring and subrings separately as 

follows: 

z 

Enable the primary ring of an RRPP domain before enabling subrings of the RRPP domain.  

z 

Disable the primary ring of an RRPP domain after disabling all subrings of the RRPP domain.  

 

Perform this configuration on the master node of an RRPP domain.  

Follow these steps to configure RRPP timers: 

Enter system view 

— 

Enter RRPP domain view 

rrpp domain domain-id 

—