3com S7906E インストール手順
1-16
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter RRPP domain view
rrpp domain domain-id
—
Specify the current device as a
transit node of the primary ring,
and specify the primary port
and the secondary port
transit node of the primary ring,
and specify the primary port
and the secondary port
ring ring-id node-mode transit
[ primary-port interface-type
interface-number ] [ secondary-port
interface-type interface-number ] level
level-value
[ primary-port interface-type
interface-number ] [ secondary-port
interface-type interface-number ] level
level-value
Required
Specify the current device as
the assistant-edge node of the
subring, and specify an edge
port
the assistant-edge node of the
subring, and specify an edge
port
ring ring-id node-mode assistant-edge
[ edge-port interface-type
interface-number ]
[ edge-port interface-type
interface-number ]
Required
Activating an RRPP Domain
To activate an RRPP domain on the current device, enable the RRPP protocol and RRPP rings for the
RRPP domain on the current device.
Perform this operation on all nodes in the RRPP domain.
Follow these steps to activate an RRPP domain:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enable RRPP
rrpp enable
Required
Disabled by default
Enter RRPP domain view
rrpp domain domain-id
—
Enable the specified RRPP ring ring ring-id enable
Required
Disabled by default
On an edge node or assistant-edge node, enable/disable the primary ring and subrings separately as
follows:
z
Enable the primary ring of an RRPP domain before enabling subrings of the RRPP domain.
z
Disable the primary ring of an RRPP domain after disabling all subrings of the RRPP domain.
Configuring RRPP Timers
Perform this configuration on the master node of an RRPP domain.
Follow these steps to configure RRPP timers:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter RRPP domain view
rrpp domain domain-id
—