3com S7906E Installation Instruction
1-6
The peer group to be configured with a description must have been created.
Disabling Session Establishment to an IPv6 Peer/Peer Group
Follow these steps to disable session establishment to a peer/peer group:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
—
Enter IPv6 address family view
ipv6-family
—
Disable session establishment to an
IPv6 peer/peer group
IPv6 peer/peer group
peer { ipv6-group-name |
ipv6-address } ignore
ipv6-address } ignore
Optional
Not disabled by default
Logging IPv6 Peer/Peer Group State Changes
Follow these steps to configure to log on the session and event information of an IPv6 peer/peer group:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
—
Enable logging of peer changes
globally
globally
log-peer-change
Optional
Enabled by default.
Enter IPv6 address family view
ipv6-family
—
Enable the state change
logging for an IPv6 peer or peer
group
logging for an IPv6 peer or peer
group
peer { ipv6-group-name |
ipv6-address } log-change
ipv6-address } log-change
Optional
Enabled by default.
Refer to BGP Commands in the IP Routing Volume for information about the log-peer-change
command.
Controlling Route Distribution and Reception
The task includes routing information filtering, routing policy application and route dampening.
Prerequisites
Before configuring this task, you need to: