Insignia is-hc040917 User Manual

VIDEO

10

SUB WOOFER

SURROUND RIGHT

SPEAKER

FRONT CENTER

SPEAKER

FRONT RIGHT

SPEAKER

RIGHT

LEFT

RIGHT

LEFT

Use this jack on the 

middle back panel to 

connect another 

powered subwoofer 

other than the one 

supplied.  

SURROUND CENTRE 

SPEAKER

When connecting the speakers, make sure the polarities ( "+" 

speaker wire to "+" on the receiver) of speaker wires and

terminals are matched. If the cords are reversed, the sound 

will be distorted and will lack bass ("out of phase" effect).

To connect your own powered subwoofer, a mono aural audio 

cord (not supplied) is needed (RCA terminal).

This receiver offers a high flexibility for user to use a large 

variety of speakers and subwoofers. For more information 

please refer to section "

Speaker Setting

" in "Operating Your 

Receiver" on page 20.

     Do not let the bare speaker wires touch each other or any metal 

     part of this unit. This could damage this unit or the speakers,or both.   

     

      Connect the  speakers terminals to your speakers with the  wire of 

      the wire of the proper gauge (keep as short as possible). if the 

     connections are faulty. no sound will be heard from the speakers. 

Method 1

Or you also may use banana plug.

SURROUND LEFT

SPEAKER

FRONT LEFT

SPEAKER

You will need to use 7 speakers with the unit (Front Left, Front 

Right, Front Center, Surround Left Surround center, Surround 

Right and subwoofer). In order to enjoy good surround effects 

all six speaker need to be connected to the receiver.

At least two front speakers (Front left and right) are required.  

For better sound quality, Center speaker, Surround speakers 

and Subwoofer should also be connected. Adding Center and  

Surround speakers will enhance surround effects. Adding a 

Subwoofer will increase bass response.

If you want to enjoy full range of sound effects, with small

speakers,it is a must to use the subwoofer with the speakers to 

maintain adequate bass signal.

 

1.

2.

3.

Loosen the knob.

Insert the bare wire.[Remove approx 5mm(1/4

) insulation 

from the speaker wires.]

Tighten the knob and secure the wire.