Xerox 7500DT User Guide
Network Basics
Phaser 7500 Color Printer
User Guide
User Guide
30
Automatically Setting the Printer’s IP Address
If the printer is connected to a small established TCP/IP network without a DHCP server, use the
installer on the Software and Documentation CD-ROM to detect or assign an IP address to your printer.
For further instructions, insert the Software and Documentation CD-ROM into your computer’s CD-ROM
drive. After the Xerox Installer launches, follow the prompts for installation.
installer on the Software and Documentation CD-ROM to detect or assign an IP address to your printer.
For further instructions, insert the Software and Documentation CD-ROM into your computer’s CD-ROM
drive. After the Xerox Installer launches, follow the prompts for installation.
Note:
For the automatic installer to function, the printer must be connected to an established
TCP/IP network.
Dynamic Methods of Setting the Printer’s IP Address
There are two protocols available for dynamically setting the printer’s IP address:
•
DHCP (enabled by default on all Phaser printers)
•
AutoIP
You can turn on/off both protocols using the control panel, or use CentreWare IS to turn on/off DHCP.
Note:
You can view the printer’s IP address at any time. On the control panel, select
Information,
press the
OK button, select Printer Identification, then press the OK button.
Using the Control Panel
To turn on/off either the DHCP or AutoIP protocol:
1. On the control panel, select
Printer Setup > Connection Setup > Network Setup > TCP/IPv4
Setup, then press the OK button.
2. Select
DHCP/BOOTP or AutoIP.
3. Press the
OK button to turn the selection On or Off.
Using CentreWare IS
To turn on/off the DHCP protocol:
1. Launch your Web browser.
2. Enter the printer’s IP address in the browser’s
Address field.
3. Select
Properties.
4. Select the
Protocols folder on the left navigation panel.
5. Select
TCP/IP.
6. Click the
TCP/IP (v4) button.
7. In the BOOTP/DHCP Settings section, set the
BOOTP/DHCP option to On or Off.
8. In the TCP/IP Settings section, enter the static IP address which may be different than the DHCP or
auto IP address listed. Check that the Network Mask and Router/Gateway address are correct for
your network.
your network.
9. Click the
Save Changes button.