Xerox C118 User Guide

Follow the steps below to set up an HP-UX workstation to communicate with the 
machine.

Log in as root at a client and add the machine to the /etc/hosts file. For example:

Ip address [tab] PrinterName

Verify connectivity to the machine, by using a UNIX command such as ping from a 
terminal command window, as shown in the following example:

ping PrinterName

NOTE: Select CTRL+C to cancel the ping command.

There are two methods to install the machine on an HP-UX workstation. Choose 
the method that will be used to complete the installation and refer to the 
appropriate page:

Using the Command Window TTY Method – page 46
Using the System Administrator Manager (SAM) GUI Method – page 47

Follow the steps below to use the command window to manually enter command 
strings.

Open a command window on the desktop. From the command prompt (#), enter 
the information below. Remember that UNIX commands are case-sensitive.

1) Type su to access the superuser mode.

2) Type sh to run the Bourne shell.

3) Type lpshut to stop the print service.

4) Type the following command on one line:

lpadmin -pqueuename -v/dev/null -mrmodel -ocmrcmodel-

osmrsmodel -ob3 -orc -ormhostname -orplp

NOTE: The queuename is the name of the print queue being created. The hostname 
is the PrinterName for the machine from the etc/hosts file.
The remote queue name must be set to lp to spool jobs to the machine. This is set by 
the -orplp command.

Type lpsched to start the print service.

Type enable queuename to enable the queue to print to the machine.

Type accept queuename to enable the queue to start accepting jobs from the 
HP-UX workstation.

NOTE: The queuename is the name of the print queue that has been created.

Type exit to exit the Bourne shell.

Type exit to exit superuser mode.

Type exit to close the command window.