Xerox C118 User Guide
Xerox CopyCentre/WorkCentre 118 System Administration Guide
71
7 TCP/IP (LPD or Port9100)
This chapter explains how to set up the machine to print from a Windows computer
through LPD or Port9100. The following information is provided.
through LPD or Port9100. The following information is provided.
Information Checklist – page 71
TCP/IP (LPD or Port9100) Environments – page 72
TCP/IP (LPD or Port9100) Installation – page 72
Installation Procedure – page 72
Network Communication Setup – page 73
Workstation Setup – page 75
Test Print – page 75
TCP/IP (LPD or Port9100) Environments – page 72
TCP/IP (LPD or Port9100) Installation – page 72
Installation Procedure – page 72
Network Communication Setup – page 73
Workstation Setup – page 75
Test Print – page 75
Information Checklist
Before starting these procedures, make sure that the following items are available or
have been performed.
have been performed.
If problems are encountered during machine setup, refer to Problem Solving chapter
for assistance.
for assistance.
CAUTION: Do not connect the network cable to the machine until instructed to
do so.
do so.
Item
By
An existing operational network utilizing TCP/IP is required. These
procedures are not designed to install a network.
procedures are not designed to install a network.
Customer
Obtain and record the following information:
• IP address
• Gateway address
• Subnet mask
• Host name
Refer to the glossary for additional information about the Gateway
Address and Subnet mask, if needed.
• IP address
• Gateway address
• Subnet mask
• Host name
Refer to the glossary for additional information about the Gateway
Address and Subnet mask, if needed.
Customer
Test the machine to make sure that it is installed fully and functioning
correctly.
correctly.
Customer
Print driver for the machine
Customer