Xerox 240 User Manual

Notice: The Canadian Industry Canada label identifies certified 
equipment. This certification means that the equipment meets 
certain telecommunications network protective, operational and 
safety requirements. The Department does not guarantee the 
equipment will operate to the user’s satisfaction.

Before installing this equipment, users should ensure that it is 
permissible to be connected to the facilities of the local 
telecommunications company. The equipment must also be installed 
using an acceptable method of connection. In some cases, the 
company’s inside wiring associated with a single line individual 
service may be extended by means of a certified connector assembly 
(telephone extension cord). The customer should be aware that 
compliance with the above conditions may not prevent degradation 
of service in some situations.

Repairs to certified equipment should be made by an authorized 
Canadian maintenance facility designated by the supplier. Any 
repairs or alterations made by the user to this equipment, or 
equipment malfunctions, may give the telecommunications 
company cause to request the user to disconnect the equipment.

Users should ensure for their own protection that the electrical 
ground connections of the power utility, telephone lines and internal 
metallic water pipe system, if present, are connected together. This 
precaution may be particularly important in rural areas.

Caution: Users should not attempt to make such connections 
themselves, but should contact the electric inspection authority, or 
electrician, as appropriate.

The Load Number (LN) assigned to each terminal device denotes 
the percentage of the total load to be connected to a telephone loop 
that is used by the device, to prevent overloading. The termination 
on a loop may consist of any combination of devices subject only to 
the requirement that the total of the Load Numbers of all the devices 
does not exceed 100.