Xerox 4050 Service Manual

PRINTER MAINTENANCE

If the files you are copying exceed the storage capacity
of the diskette, the system displays the following
messages:

** DISKETTE IS FULL ** 

REMOVE CURRENT DISKETTE

AND INSERT ANOTHER DISKETTE

ENTER: C

CONTINUE 

COPYING

X

TO ABORT CURRENT SAVE

Unload the diskette in the drive and load a formatted
disk, then enter C to continue the copying process.

f.

To copy files from a diskette to the system disk, enter
the following command:

FLOPPY RESTORE [REVIEW] [disk-id [input-file-id
[output-file-id] ALL|file-type]

REVIEW

Displays a warning message when the file to be
copied is about to overwrite a file of the same name
already on the system disk, and asks if you want to
continue.  Enter Y to overwrite the file, N to skip
the file, or X to abort the copy process.

[disk-id]

Identifies the system disk  to copy the file to (DP1:,
DP2:, or DP3:).  You do not need to enter this
parameter.

Specifies the full name of the file to copy (including
its extension).

[output-file-id]

Specifies the name of the file to be written if it is
different than the name of the source file.  If
output-file-id is not specified, the name of the
source file is used.

ALL|file-type

Specifies the files to copy.

ALL

Copies all files on the tape to the system disk.

Copies all files with a specified extension (file
type) to the system disk.

Observe the following guidelines when handling diskettes:

•

Hold the diskette by its cover.  Do not touch the portions
that show through the cutout areas in the disk cover.

•

Store the diskette in its protective sleeve when it is not in
use.

•

Write on diskette labels before you apply them to the
diskette.  Do not write on diskettes or on labels that are
attached to the diskette.

•

Do not attempt to clean a diskette.

XEROX 4050/4090/4450/4650 LPS OPERATOR GUIDE

6-15