Xerox 4050 Service Manual
PRINTER MAINTENANCE
•
Do not expose diskettes to excessive heat or sunlight, or to
magnets or magnetized objects such as displays, telephones,
and so forth.
magnets or magnetized objects such as displays, telephones,
and so forth.
•
Do not bend or fold a diskette.
Follow these steps to load a diskette:
1. Make sure that the disk drive lever is in the open position.
If the lever is in the closed position, there may be a diskette
loaded in the drive. Turn the lever to the open position and
remove the diskette.
loaded in the drive. Turn the lever to the open position and
remove the diskette.
2. Insert the diskette with the label facing to the left until it is
completely inside the drive.
You can feel the diskette hit the stops.
3. Turn the lever clockwise 1/4 turn to the closed position.
If you feel any resistance when turning the lever, make sure
that the diskette is inserted completely into the drive.
that the diskette is inserted completely into the drive.
Formatting a diskette
You must format a diskette before you use it.
CAUTION: Formatting a disk erases all data on the diskette.
Before you format a diskette, verify that the diskette is
unformatted (has never been used) or that the information on
the diskette can be erased.
Before you format a diskette, verify that the diskette is
unformatted (has never been used) or that the information on
the diskette can be erased.
1. Load the diskette.
For more information about loading a diskette, refer to the
“Loading and unloading a floppy diskette from the system
controller” section in the “Setting up print job sources”
chapter.
“Loading and unloading a floppy diskette from the system
controller” section in the “Setting up print job sources”
chapter.
6-16
XEROX 4050/4090/4450/4650 LPS OPERATOR GUIDE