Xerox 4517 User Guide
I n s t a l l i n g a n d R e m o v i n g P r i n t e r O p t i o n s
A p p e n d i x C : I n s t a l l i n g a n d R e m o v i n g P r i n t e r O p t i o n s ❖ C-55
Xerox
Network
Interface Card
(XNIC)
This section contains two sets of instructions:
•
“Installing the XNIC” (page C-56)
•
“Removing the XNIC” (page C-60)
These instructions apply to Ethernet (XNIC-E’NET), Token
Ring (XNIC-T’RING) and LocalTalk (XNIC-L’TALK).
Caution
The XNIC and controller board are sensitive to static
electricity. Before installing the XNIC, discharge static
electricity from your body by touching something metal, such
as the metal back plate on any device plugged into a
grounded power source. If you walk around before finishing
the installation, again discharge any static electricity.
electricity. Before installing the XNIC, discharge static
electricity from your body by touching something metal, such
as the metal back plate on any device plugged into a
grounded power source. If you walk around before finishing
the installation, again discharge any static electricity.
Never remove the printer controller board while the printer is
plugged in.
plugged in.
Note
The printer is capable of supporting two XNICs; however, do
not install two of the same XNICs in the printer.
chapterc.frm Page 55 Friday, July 11, 1997 9:25 PM