Xerox 300x User Guide
3
Calibrating the Printer
3-22
PhaserMatch
Saving calibration settings
Note
The Save Calibration command is available only in the Expert
Calibration user mode. Refer to page 2-9 for instructions on
selecting this user mode.
Calibration user mode. Refer to page 2-9 for instructions on
selecting this user mode.
Use the Save Calibration dialog box to save the settings you made in the
Gray Balance, Gray Linearity, or Calibration Curves dialog boxes to a file on
your computer.
Gray Balance, Gray Linearity, or Calibration Curves dialog boxes to a file on
your computer.
The printer’s memory stores separate calibration settings for each type of
transfer roll: 4-Color, 3-Color, and Black-only. If you switch between these
different types of transfer rolls, the printer automatically uses the
appropriate settings for the currently installed transfer roll.
transfer roll: 4-Color, 3-Color, and Black-only. If you switch between these
different types of transfer rolls, the printer automatically uses the
appropriate settings for the currently installed transfer roll.
1.
Select Save Calibration from the File menu.
2.
In the Save Calibration dialog box, select a name to replace from
the list of existing calibration settings, or type in a new name. The
name can be up to 25 characters long.
the list of existing calibration settings, or type in a new name. The
name can be up to 25 characters long.
3.
Click OK to save the new calibration setting in your computer.
■
The last values you sent to the printer are saved in the printer until
you change them.
you change them.
■
Saved settings are available in the Load Calibration dialog box.
■
When you quit PhaserMatch, you are prompted to save any
calibration settings you have modified but haven’t yet saved.
calibration settings you have modified but haven’t yet saved.