Xerox 750P Installation Instruction

Disabling and Enabling Protocols

After your network configuration is complete, you may want to disable protocols that you 
are not using to avoid unnecessary network traffic.  There are four ways to disable 
protocols:

■

Use the printer’s front panel; see Disabling and enabling protocols: Phaser 750 front 
panel on page 43.

■

In NetWare environments, you can use the PhaserShare Administrator; see Disabling 
protocols: PhaserShare Administrator on page 43.

■

With a TCP/IP connection and a World Wide Web browser, you can use PhaserLink 
Printer Management Software; see Disabling protocols: PhaserLink Printer 
Management Software on page 44.

■

Send the appropriate PostScript utility file to the printer.  See the README files on 
the printer’s CD-ROM.  The PC README file is in the UTILS directory; the Macintosh 
README file is in the Network Utilities folder.

You can enable protocols by the same procedures; just select the command to enable a 
protocol rather than disable it.

Determining which protocols are enabled

All protocols can be enabled and disabled.  The Configuration Page reports which 
protocols are enabled.  If a protocol is enabled, the field for that protocol lists the current 
parameters.  If the protocol is disabled, the field for that protocol contains an entry reading 
Disabled.