Xerox 242 Supplementary Manual

218

Chapter 9 – Reinstalling the Spire CX260

 

Before performing the recovery procedure, the system must be in the configuration 
mode that you want to recover.

1.

Using the tip of a pen or similar object, push the RCVR button on the front of the 
Spire CX260.

2.

From your Windows-based computer, Macintosh computer, or portable 
workstation, connect to the Spire CX260 via the RDC utility. See Working from 
the Remote Desktop Application on page 86.

3.

On the desktop, select 

Start > CX260  > CX260 Tools > System Backup and 

Restore > Show current recovery type.

4. When the following window appears, click 

OK. 

5.

To exit recovery mode without initiating the recovery process, push the RCVR 
button again.

LED 7 turns off.

When you restore the Last Image configuration, the job list database from that 
backup will also be restored. The current job list database will be replaced with the 
old job list that was saved while backing up Last Image configuration. 

To restore the Last Image configuration, the operating system must be in Last Image 
mode. See Verifying the Current Recovery Type on page 217.

Note:  The default Spire CX260 backup configuration is the Last Image 
configuration.

Note:  This step is required only on the CX260 Basic configuration.

Note:  If the current recovery type is Factory Default, the message 

Current Recovery type is Factory Default

 appears.