Xerox 6128MFP User Guide

System Setup menu is used to make the printer operation settings, such as for alarm and 
power saver mode.

Fwd. Set Print

Specifies if the outgoing faxes should be printed when they 
are forwarded. When set to On, all of the forwarded faxes 
are printed.

Fwd. Error Print

Prints a report if a forwarded fax is not successfully sent.

Prefix Dial

Specifies whether or not to add the prefix number when you 
send a fax.

Prefix Dial Num

Specifies the prefix dial number, up to five digits. This number 
dials before any auto dial number is started. It is useful for 
accessing the PABX exchange.

Discard Size

Specifies if the printer should discard any excess data at the 
bottom of the page.

ECM (Error Correction Mode)

If ECM is set to On (the default), it attempts to correct errors 
in the fax transmission, caused by problems, such as a noisy 
telephone line. 

Extel Hook Thresh

Specifies the threshold value for the external telephone.

Modem Speed

Specifies the fax modem speed.

Country

Specifies the country where the printer is used.

Power Saver Timer

Specifies the transitional time of Power Saver Modes 1 and 2 in increments of 1 minute.
• Mode 1 (Printer)  

1 min. to 60 min. (default is 30 minutes)

• Mode 2 (System)  

5 min. to 120 min. (default is 30 minutes)

For details, refer to 

Auto Reset

Specifies the time the printer waits for further control panel input before 
automatically resetting the settings for COPY, SCAN, or FAX and returning to the 
standby mode.

Fault Time-Out

You can cancel a printing process when it goes beyond a set time period. Set the time 
until the print job is canceled. When this timeout expires, the print job is canceled.
• 5 sec. to 300 sec. (default: 30 sec.) 

Specifies the amount of time in increments of 1 second the printer waits for 
additional data before it cancels the job.

• Off 

Cannot cancel.