Xerox 6110MFP User Manual

Installing Printer Software in Windows

6

: If your printer is not already connected to the 

computer, the following window will appear.

• After connecting the printer, click Next.
• If you don’t want to connect the printer at this time, click 

Next, and No on the following screen. Then the installation 
will start and a test page will not be printed at the end of the 
installation.

Select the components to be installed and click Next.

: You can change the desired installation folder by 

clicking [Browse].

After the installation is finished, a window asking you to 
print a test page appears. If you choose to print a test 
page, select the checkbox and click Next.
Otherwise, just click Next and skip to step 9.

If the test page prints out correctly, click Yes.
If not, click No to reprint it.

Click Finish.

When you connect your printer to a network, you must first 
configure the TCP/IP settings for the printer. After you have 
assigned and verified the TCP/IP settings, you are ready to 
install the software on each computer on the network.

You can install the printer software using the typical or custom 
method.

This is recommended for most users. All components necessary 
for printer operations will be installed.

Make sure that the printer is connected to your network 
and powered on. For details about connecting to the 
network, see the supplied printer’s User’s Guide.

Insert the supplied CD-ROM into your CD-ROM drive.
The CD-ROM should automatically run, and an installation 
window appears.
If the installation window does not appear, click Start and 
then Run. Type X:\Setup.exe, replacing “X” with the 
letter which represents your drive and click OK.

Click Install Software. 

Select Typical installation for a network printer. Click 
Next.