Xerox 6110MFP User Manual

.1   

<Loading originals and print media>

This chapter introduces you to how to load originals and print media into 
your machine.

This chapter includes:

You can use the scanner glass or ADF to load an original for copying, 
scanning, and sending a fax.

Make sure that no originals are in the ADF. If an original is detected in 
the ADF, the machine gives it priority over the original on the scanner 
glass. To get the best scan quality, especially for coloured or gray-scaled 
images, use the scanner glass.

Lift and open the scanner lid.

Place the original face down on the scanner glass and align it with 
the registration guide at the top left corner of the glass.

Close the scanner lid.

Using the ADF, you can load up to 50 sheets of paper (75 g/m

2

, 20 lb) 

for one job. 

When you use the ADF:
• Do not load paper smaller than 142 x 148 mm (5.6 x 5.8 inches) or 

larger than 216 x 356 mm (8.5 x 14 inches).

• Do not attempt to load the following types of paper:

- carbon-paper or carbon-backed paper
- coated paper
- onion skin or thin paper
- wrinkled or creased paper
- curled or rolled paper
- torn paper

• Remove all staples and paper clips before loading.
• Make sure any glue, ink, or correction fluid on the paper is completely 

dry before loading.

• Do not load originals that include different sizes or weights of paper.
• Do not load booklets, pamphlets, transparencies, or documents 

having other unusual characteristics.

• Leaving the scanner lid open while copying may affect copy 

quality and toner consumption.

• Dust on the scanner glass may cause black spots on the 

printout. Always keep it clean.

• If you are copying a page from a book or magazine, lift the 

scanner lid until its hinges are caught by the stopper and then 
close the lid. If the book or magazine is thicker than 30 mm, 
start copying with the lid open.