Xerox 6180MFP User Guide

There are three submenus under the Tray Settings menu: Tray 1 (MPT), Tray 2, and Tray 3. 
You can set paper size and paper type for each tray under these menus. (Display Pop-up and 
MPT Mode can only be set for Tray 1 (MPT).)

Tray 3 is displayed only when the optional sheet feeder is installed.

The settings menu for Tray 1 (MPT) is displayed only when the MPT Mode is set to Panel 
Specified.

■

Paper Type: Specifies the type of paper loaded in each tray.

■

Tray 1 (MPT) (default: Thin Card Stock)

■

Tray 2 (default: Plain)

■

Tray 3 (default: Plain)

For details, refer to 

■

Paper Size: Specify the paper size and orientation for each tray. 

■

Tray 1 (MPT) (default: Driver Size)

■

Tray 2 (default: Auto)

■

Tray 3 (default: Auto)

For details, refer to 

■

Display Popup: Specifies whether or not to display the message that prompts you to set 
the paper size and type every time you load paper in Tray 1 (MPT).

When you select On, the message that prompts you to set the paper size and type is 
displayed. The default is Off.

■

MPT Mode: Specifies the way to set the paper type and size settings to be loaded in 
Tray 1 (MPT). When the size or type of paper that is loaded is different from the setting, 
the print quality may suffer or paper may jam. Specify the correct paper type and size.

■

Panel Specified (default): You can specify the paper type and size settings on the 
control panel. Printing can be done only when the settings on the print driver match 
the settings on the control panel. When a mismatch of paper sizes occurs, follow the 
instructions displayed on the control panel.

■

Driver Specified: You cannot specify the settings on the control panel. Printing is 
done using the settings on the print driver.

When installing the optional sheet feeders if Paper Tray is set to Auto on the print driver, the 
feeding tray is automatically specified according to the setting on the control panel. Also, 
when the paper size and type setting for each tray is the same, printing continues by changing 
the feeding tray if the paper in the specified tray has run out.