Xerox 8510 Supplementary Manual

The following procedure eliminates cabling, communication, and connection problems. Once 
you complete these steps, print a test page from your software application. 

If the job prints, no further system troubleshooting is necessary. If there are 

print-quality problems, see the User Guide at 

.

Perform these steps only for Mac OS 9:

Open the Chooser, and then click the LaserWriter driver.

Do one of the following:

■

If the system’s name appears, your device is communicating through the network. You 
do not need to perform any additional steps.

■

If the system’s name does not appear, proceed to Step 3.

Verify that the system is plugged in, turned On, and connected to an active network.

Verify the cable connection from the network to the system.

Follow these steps:

From the system’s control panel, verify that EtherTalk is enabled. If it is not, enable it 
in the control panel, and then reset the system.

Print the Configuration page and verify that EtherTalk is enabled.

From the Configuration page, verify the Zone. If you have multiple zones on your 
network, verify that your system appears in the desired zone.

If you are still unable to print, access PhaserSMART Technical Support through 
CentreWare IS:

Launch your web browser.

Enter the system’s IP address in the browser’s Address field (http://xxx.xxx.xxx.xxx). 

Select Support. 

Click the PhaserSMART Diagnostic Tool link to access PhaserSMART.