Xerox 123 User Guide
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128/133 System Administration Guide
71
6 Microsoft Networking
This chapter explains how to set up the machine to operate on a Microsoft network. The
following information is provided.
Information Checklist – page 71
SMB Environments – page 72
SMB Installation – page 73
Installation Procedure – page 73
Network Communication Setup – page 73
Workstation Setup – page 75
Test Print – page 75
Changing the Settings – page 75
Procedure – page 75
Setting Format of config.txt – page 76
following information is provided.
Information Checklist – page 71
SMB Environments – page 72
SMB Installation – page 73
Installation Procedure – page 73
Network Communication Setup – page 73
Workstation Setup – page 75
Test Print – page 75
Changing the Settings – page 75
Procedure – page 75
Setting Format of config.txt – page 76
Information Checklist
Before starting the Microsoft networking installation procedures, make sure that the
following items are available or have been performed.
following items are available or have been performed.
If problems are encountered during the installation, refer to the Problem Solving
chapter for assistance.
chapter for assistance.
CAUTION: Do not connect the network cable to the machine until instructed to
do so.
do so.
Item
By
An existing operational Microsoft network is required. These procedures
are not designed to install a Microsoft network.
are not designed to install a Microsoft network.
Customer
Obtain and record the following information, if required:
• IP address
• Gateway address
• Subnet mask
• Host name
Refer to the glossary for additional information about the Gateway
Address and Subnet mask, if needed.
• IP address
• Gateway address
• Subnet mask
• Host name
Refer to the glossary for additional information about the Gateway
Address and Subnet mask, if needed.
Customer
Test the machine to make sure that it is installed fully and functioning
correctly.
correctly.
Customer
Install the print driver.
Customer