Xerox 123 User Guide

This section describes the installation procedure for using the machine on an SMB 
network.

The installation procedure is as follows.

Network Communication Setup
When using NetBEUI:

Set the SMB port to [Enabled] using the touch screen or CentreWare Internet 
Services.

When using TCP/IP:

Set the SMB port to [Enabled] using the touch screen or CentreWare Internet 
Services. Set the IP address on the control panel.

Workstation Setup
Install the print driver on the computer.

Test Print
A print job should be submitted to make sure that the machine has been installed and 
configured correctly.

This procedure is used to set up the network communication parameters of the 
machine.
At the machine, perform these steps.
NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP 
network.

NOTE: CentreWare Internet Services can also be used to configure the machine. 
Refer to the CentreWare Internet Services chapter of the User Guide.

Initially, boot the SMB port.

Connect the machine to the network.

Display the [System Settings] screen.

NOTE: For more information about how to display the [System Settings] screen, refer 
to the Setups chapter of the User Guide.

Select [Network Settings].

Select [Port Settings].